Innovation of the month in Motorcycle Consumer News MagazineDesigned for bikes without center-stands Easily clean front or back wheels Easy one person operation No danger of dropping bike Powder Coated Sealed bearings Non-slip backing Cruiser model great for bearing and shim alignment For sportbikes and cruisers SAFETY WARNING:THIS PRODUCT IS A CLEANING AID FOR MOTORCYCLE WHEELS. THIS CLEANING AID MUST NEVER BE USED WITH MOTORCYCLE ENGINE RUNNING OR WITH THE MOTORCYCLE IN GEAR. THE MANUFACTURER WARNS THAT WHEEL ROTATION MUST BE BY HAND ONLY. THE MANUFACTURER ACCEPTS NO LIABILITY FOR INJURY TO PERSONS OR DAMAGE TO PROPERTY THAT MAY RESULT FROM THE USE OR ABUSE OF THIS CLEANING AID. INSTRUCTIONS FOR USE:1. Use the Rollastand on a flat and level area such as a concrete driveway or workshop floor. Do not use the Rollastand on sloping or uneven surfaces.2. Make sure that the motorcycle ignition is switched off and the gears are in neutral. FOR REAR WHEEL USE:1. Place the Rollastand 15 inches behind the back wheel.2. Make sure that the rollers of the Rollastand are at right angles to the direction the wheel to be cleaned. See photos on packaging or above.3. Take the weight of the Motorcycle off the side stand and manually roll the motorcycle onto the Rollastand. You will feel a small bump as the Motorcycle wheel rides over the first roller allow the wheel to come to rest between the rollers. Allow the motorcycle to rest on the kickstand with the steering at full left lock.4. Some owners may feel that their motorcycle is leaning too much at this point. Add a small wood block under the side stand to adjust the attitude of the motorcycle.5. The motorcycle rear wheel can now be rotated by hand to assist with cleaning or chain maintence.FOR FRONT WHEEL USE.1. Place the Rollastand 15 inches in front of the front wheel.2. Make sure that the rollers of the Rollastand are at right angles to the direction the wheel to be cleaned. See photos on packaging or above.3. Take the weight of the Motorcycle off the side stand and manually roll the motorcycle onto the Rollastand. You will feel a small bump as the Motorcycle wheel rides over the first roller allow the wheel to come to rest between the rollers. Keep the front wheel pointed straight ahead.4. Some owners may feel that their mtorcycle is leaning too much at this point. Add a small wood block under the side stand to adjust the attitude of the motorcycle.5. The motorcycle rear wheel can now be rotated by hand to assist with cleaning. The front wheel may nove to one side of the Rollastand as it is being rotated. This can be corrected by changing the direction of the front wheel as it is being rotated.Your Rollastand is protected by a powder-coated finish and has sealed bearings for a long service life. Wipe dirt oil off with a rag. Do not immerse in solvents. Store in a dry place. Rollastand comes with a 12 month warranty against defective materials and workmanship.
